Home » What We Offer » Gas Drying System

Gas Drying System

Capitalizing on our sophisticated manufacturing unit we are able to design, develop and offer superior quality compressed gas drying system. Our comprehensive range of compressed air drying system and gas drying system is fabricated using qualitative raw material in the production process to ensure effectiveness and durability. Some of our range encompasses heatless type dryer, heat reactivated type dryer, heat of compression type dryer etc.

Heatless Type Dryer

Wet incoming compressed air or gas is passed through a desiccant bed; the desiccant adsorbs its moisture. After some time of operation, this desiccant gets saturated and needs regeneration. Reactivation or regeneration of desiccant is then necessary to drive-off the adsorbed moisture and to re-store its original absorptive capacity. This is accomplished via purging the adsorbent by dry air or gas at atmospheric pressure and temperature in reverse direction.

Actual Operation: Heatless Drying Unit has two towers filled with the desiccant for continuous drying operation. At a time, one tower is used for drying while the other tower is reactivated simultaneously. After a fixed time of interval, the drying towers get changeover automatically by operation of sequence timer and interconnected valves. Referring to the flow diagram, assume that the left tower is under DRYING and the right tower is under Reactivation. Wet air or gas enters the tower from bottom side, passes up through the desiccant and comes out from the top. A small bleed flow is split from the exit of left tower and enters the right tower at atmospheric pressure. This bleed air pick-up the moisture from the desiccant and vented out to the atmosphere. After complete reactivation of desiccant, direction of control valves is reversed to place the left tower on reactivation and

Salient Features:

Low initial installation and operating cost. High performance and almost Zero maintenance cost.
Low temperature operation which reduces corrosion of towers.
Only single phase electric power is required.
Desiccant life around 3 – 5 years.

Capacities Offered: 10 NM3 / HR TO 1000 NM3 / HR

Heat less Air Dryer (Dimensions): The above capacities are designed at an inlet conditions of 40 degree Celsius temp., 7 – 10 kg/cm2 pr. and at an outlet Dew – Point of (-) 40 degree Celsius.

Supply Voltage:- Single Phase, 220V, 50Hz.

Send Enquiry

Mr. J. P. Sharma / Mr. Suresh Sanadhya (CEO)
S. F. - 37, Sitaram Super Market, Chhani Road, Opposite Baroda Packaging
Vadodara, Gujarat - 390 002, India
Telephone:+(91)-(265)-2777340

Contact via E-mail

Contact via Mobile

Contact via SMS

© Airro Engineering Company, All Rights Reserved. (Terms of Use)
Developed and Managed by IndiaMART InterMESH Limited